...OOO...

...nOs han visitado i visitan desde Toda la ...Madre Tierra...*...

Insignia

kargamdO…

...Este es un sitiO donde podemos aprender ejemplos de Vida Sustentables ...Casa Conciente se Autosuficiente... ...EKOSMUNiDAD...

...Bibliotecas de Livreinatural...

contador de visitas

...Tan Necesario Como el Buen Futuro... Hacer Nuestro Carbon Activado... Aqui un primer ṕaso de este Objetivo...

Primitive Technology
Publicado el 19 feb. 2016
I made a batch of charcoal using the mound method then stored it in baskets for later use. Charcoal is a fuel that burns hotter than the wood it's made from. This is because the initial energy consuming steps of combustion have taken place while making the charcoal driving off the volatile components of the wood (such as water and sap). The result is a nearly pure carbon fuel that burns hotter than wood without smoke and with less flame. Charcoal was primarily a metallurgical fuel in ancient times but was sometimes used for cooking too.

To make the charcoal the wood was broken up and stacked in to a mound with the largest pieces in the center and smaller sticks and leaves on the out side. The mound was coated in mud and a hole was left in the top while 8 smaller air holes were made around the base of the mound. A fire was kindled in the top of the mound using hot coals from the fire and the burning process began (the hot coals are being poured in the top using a small pot at 2:38).

The fire burned down the inside of the mound against the updraft. I reason that this is a better way to make charcoal as the rising flames have used up the oxygen and prevent the charcoal already made above them from burning while driving out even more volatiles .

I watched the air holes at the base of the mound and when the fire had burned right up to each opening I plugged them with mud. Once all 8 holes had be sealed the hole in the top of the mound was sealed with mud and the mound left to cool. From lighting the mound to closing up the holes the whole process took about 4 hours.

The next day when the mound was cool to the touch (this can take about 2 days sometimes) I opened the mound. The resulting charcoal was good quality. Some wood near the air entries had burned to ash though these were only small twigs and leaves. This is the reason small brush is put on the out side of the mound, to be burned preferentially to the larger wood on the inside thus protecting the large pieces of charcoal.

The charcoal that was made was hard and shiny. When broken open it had the ray structure of the wood preserved. When moving the hand through it the charcoal sounded tinny, like coral on a beach being moved by waves. These are signs of good quality. Bad charcoal is soft, breaks easily and has a muffled sound.

I intend to use the charcoal to produce hotter fires than I'm able to with wood alone. From my research, a natural draft furnace using wood (a kiln) can reach a maximum of 1400 c degrees whereas a natural draft furnace using charcoal can reach 1600 c degrees. Achieving high temperatures is necessary for changing material to obtain better technology (e.g. smelting ore into metal).

Wordpress: https://primitivetechnology.wordpress...
Patreon page: https://www.patreon.com/user?u=294588...
I have no face book page. Beware of fake pages.

Vistas: 3

Favorito de 1 persona
...UvikAxiOm... EKOSMUNiDAD

Agregar un Comentario

¡Tienes que ser miembrO de ...Livre i Natural... para agregar Comentarios!

Únete a ...Livre i Natural...

© 2017   Creada por EkOsmunidad ArkOiris.   Con tecnología de

Insignias  |  Informar un problema  |  Términos de servicio